I have a CTc RepRap Prusa i3 DIY printer. It has a 2560 Rev A board. Using an SD card it works very well, but I can not get my PC to communicate with the printer. I have followed the advice offered in every forum,but to no avail. Can anyone suggest a method of connecting the printer to the PC with ongoing checks to indicate any problems.? https://reprap.org/forum/read.php?406,801242,801242#msg-801242 Wed, 22 Jul 2026 07:30:01 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?406,801242,801392#msg-801392 https://reprap.org/forum/read.php?406,801242,801392#msg-801392 try this i have the same printer works a treat with no problems

[www.repetier.com]]]> Thereaper Prusa i3 and variants Mon, 18 Dec 2017 12:52:42 -0500 https://reprap.org/forum/read.php?406,801242,801244#msg-801244 https://reprap.org/forum/read.php?406,801242,801244#msg-801244
[www.thingiverse.com]]]> Bee69 Prusa i3 and variants Sun, 17 Dec 2017 14:10:02 -0500 https://reprap.org/forum/read.php?406,801242,801242#msg-801242 https://reprap.org/forum/read.php?406,801242,801242#msg-801242 scottowner Prusa i3 and variants Sun, 17 Dec 2017 13:54:38 -0500