As the title says, how can the files on the boards be upload to a PC, then edited? dlw https://reprap.org/forum/read.php?406,821834,821834#msg-821834 Wed, 16 Sep 2026 08:26:36 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?406,821834,821916#msg-821916 https://reprap.org/forum/read.php?406,821834,821916#msg-821916 The command ( IIRC) is M503.]]> o_lampe Prusa i3 and variants Sat, 12 May 2018 02:49:32 -0400 https://reprap.org/forum/read.php?406,821834,821868#msg-821868 https://reprap.org/forum/read.php?406,821834,821868#msg-821868 OK, the post was not worded correctly.
How can the Ramps 1.4 firmware be uploaded to a PC? I did this a couple of years ago before getting the Tronxy.

dlw]]> dlw Prusa i3 and variants Fri, 11 May 2018 11:18:02 -0400 https://reprap.org/forum/read.php?406,821834,821835#msg-821835 https://reprap.org/forum/read.php?406,821834,821835#msg-821835
This is akin to trying to remove the raw ingredient from a cake

You need the original source code, or just start a fresh with latest firmware.]]> Dust Prusa i3 and variants Thu, 10 May 2018 21:37:00 -0400 https://reprap.org/forum/read.php?406,821834,821834#msg-821834 https://reprap.org/forum/read.php?406,821834,821834#msg-821834
dlw]]> dlw Prusa i3 and variants Thu, 10 May 2018 21:17:57 -0400