I'm trying to figure out G33 Delta Auto Calibration on my Anycubic Kossel Plus. No probe so I was planning on doing the paper method with G33. Using a fresh copy of the latest Marlin FW 1.1.5 #9c00cff from github. I've copied the example configurations from delta/kossel_mini and tried to activate DELTA_AUTO_CALIBRATION and the requirements (LCD_BED_LEVELING and PROBE_MANUALLY) but I'm not sure what option I should select under Bed Leveling? I've tried with ABL_Linear but it's throwing an error msg about lcd_probe_pt not declared in scope. Here is my configuration.h and scroll to the bottom for error log. [paste.ee] (I haven't copied over my settings to this config yet for rod length etc but that shouldn't matter) I've tried with UBL also but then it's complaining that I need to activate PROBE_MANUALLY which I obviously have. But I'm not really interested in UBL so I can't be bothered dealing with that bug too... Any ideas on what I can check? Or if anyone has a working FW (using probe_manually) that I can compare with? https://reprap.org/forum/read.php?415,789419,789419#msg-789419 Fri, 14 Aug 2026 02:14:56 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?415,789419,789419#msg-789419 https://reprap.org/forum/read.php?415,789419,789419#msg-789419 Using a fresh copy of the latest Marlin FW 1.1.5 #9c00cff from github.

I've copied the example configurations from delta/kossel_mini and tried to activate DELTA_AUTO_CALIBRATION and the requirements (LCD_BED_LEVELING and PROBE_MANUALLY) but I'm not sure what option I should select under Bed Leveling? I've tried with ABL_Linear but it's throwing an error msg about lcd_probe_pt not declared in scope.

Here is my configuration.h and scroll to the bottom for error log.
[paste.ee]

(I haven't copied over my settings to this config yet for rod length etc but that shouldn't matter)


I've tried with UBL also but then it's complaining that I need to activate PROBE_MANUALLY which I obviously have. But I'm not really interested in UBL so I can't be bothered dealing with that bug too...


Any ideas on what I can check? Or if anyone has a working FW (using probe_manually) that I can compare with?]]> Eiktyrner Firmware - Marlin Sat, 23 Sep 2017 12:29:57 -0400