Hello, I`m printing with clay using the E0 stepper inside the extruder head and an air compressor to feed the extruder with clay. I want to replace the compressor with another stepper that pushes a plunger, helped with a gearbox, so i need the same movement in both steppers. I achieve installing the second stepper and moving it with the G-code but picking out first the one that i want to move with T0 and T1, so i can`t move them simultaneously with the same order. The Firmware I`m using is Marlin 1.1.9, and the board is a Trigorilla (Anycubic Kossel) which is equivalent to the RAMPS 14, Thanks in advance https://reprap.org/forum/read.php?415,861468,861468#msg-861468 Fri, 09 Oct 2026 00:54:18 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?415,861468,861505#msg-861505 https://reprap.org/forum/read.php?415,861468,861505#msg-861505 reprap.org]
Where I have attempted to answer them..]]> Dust Firmware - Marlin Mon, 28 Oct 2019 05:54:48 -0400 https://reprap.org/forum/read.php?415,861468,861470#msg-861470 https://reprap.org/forum/read.php?415,861468,861470#msg-861470 VDX Firmware - Marlin Sun, 27 Oct 2019 14:09:11 -0400 https://reprap.org/forum/read.php?415,861468,861468#msg-861468 https://reprap.org/forum/read.php?415,861468,861468#msg-861468
I`m printing with clay using the E0 stepper inside the extruder head and an air compressor to feed the extruder with clay.
I want to replace the compressor with another stepper that pushes a plunger, helped with a gearbox, so i need the same movement in both steppers.
I achieve installing the second stepper and moving it with the G-code but picking out first the one that i want to move with T0 and T1, so i can`t move them simultaneously with the same order.

The Firmware I`m using is Marlin 1.1.9, and the board is a Trigorilla (Anycubic Kossel) which is equivalent to the RAMPS 14,

Thanks in advance]]> Adriano JG Firmware - Marlin Sun, 27 Oct 2019 13:52:19 -0400