Can't set BLTouch probe offset in Marlin TH3D V1.R2.10d Can't set BLTouch probe offset in Marlin TH3D V1.R2.10d When I go into Control -> motion -> probe z offset the maximum negative value I'm allowed to input is -4.975 but this still leave the print nozzle approximately 8mm from the bed. Does anyone know what's going on? Why can't I set the probe z offset? Everything else with the BLTouch installation is working. I'm not sure this is the correct forum so if not apologies and please direct me to the correct forum. Thanks all in advance. https://reprap.org/forum/read.php?415,872033,872033#msg-872033 Fri, 07 Aug 2026 12:35:25 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?415,872033,872037#msg-872037 Re: Can't set BLTouch probe offset in Marlin TH3D V1.R2.10d https://reprap.org/forum/read.php?415,872033,872037#msg-872037 onearmpilot Firmware - Marlin Wed, 06 May 2020 09:54:38 -0400 https://reprap.org/forum/read.php?415,872033,872034#msg-872034 Re: Can't set BLTouch probe offset in Marlin TH3D V1.R2.10d https://reprap.org/forum/read.php?415,872033,872034#msg-872034 forum.th3dstudio.com]]]> Dust Firmware - Marlin Wed, 06 May 2020 08:25:21 -0400 https://reprap.org/forum/read.php?415,872033,872033#msg-872033 Can't set BLTouch probe offset in Marlin TH3D V1.R2.10d https://reprap.org/forum/read.php?415,872033,872033#msg-872033 When I go into Control -> motion -> probe z offset the maximum negative value I'm allowed to input is -4.975 but this still leave the print nozzle approximately 8mm from the bed.

Does anyone know what's going on?
Why can't I set the probe z offset?

Everything else with the BLTouch installation is working. I'm not sure this is the correct forum so if not apologies and please direct me to the correct forum.

Thanks all in advance.]]> onearmpilot Firmware - Marlin Wed, 06 May 2020 07:22:34 -0400