override bed temperature limit without having to set everything up again? Hi there, I built P3steel few years ago and it works like a charm. The firmware is also few years old and i know i should update. :) I will, when i have time to figure out all the steps/mm and endstop positions, etc.. My current problem is that i need to set bed temperature to 110C, but i had originally set a 100C limit in the Marlin firmware. Because still have some issues with ABS warping in larger prints. I can usually print smaller ABS well at the center of the bed using 100C temperature. I tried using the display menu and set bed temp to 110C, but printer halted at 100C, because the limit is hardcoded in the firmware. Is there a way to override bed temperature limit? I don't have the original Marlin files anymore as they went when my laptop went. It would have been easier that way... https://reprap.org/forum/read.php?415,872618,872618#msg-872618 Mon, 08 Jun 2026 06:56:25 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?415,872618,872804#msg-872804 Re: override bed temperature limit without having to set everything up again? https://reprap.org/forum/read.php?415,872618,872804#msg-872804 However, if Repetier has a setting under configuration/printer settings/extruder for Max extruder and Max bed temps. You can create different configs and set it for each. You can also change it while connected to a printer but you must disconnect to change a different one.
There is probably similar settings in other control software.]]> ruggb Firmware - Marlin Wed, 20 May 2020 22:41:28 -0400 https://reprap.org/forum/read.php?415,872618,872618#msg-872618 override bed temperature limit without having to set everything up again? https://reprap.org/forum/read.php?415,872618,872618#msg-872618
I built P3steel few years ago and it works like a charm.
The firmware is also few years old and i know i should update. :) I will, when i have time to figure out all the steps/mm and endstop positions, etc..

My current problem is that i need to set bed temperature to 110C, but i had originally set a 100C limit in the Marlin firmware.
Because still have some issues with ABS warping in larger prints. I can usually print smaller ABS well at the center of the bed using 100C temperature.

I tried using the display menu and set bed temp to 110C, but printer halted at 100C, because the limit is hardcoded in the firmware.

Is there a way to override bed temperature limit?

I don't have the original Marlin files anymore as they went when my laptop went. It would have been easier that way...]]> Veesta Firmware - Marlin Sat, 16 May 2020 16:22:57 -0400