Ok i thought i would post this here for relevance and searchable material as i struggled myself to understand what i needed to do to run the duet 0.85 from the computer alone without no bridge or needing a router or cross over cable as my delta i wanted it to be able to take it places where there might not be router, now this as i believe will only work if your adapter has autoconfiguration, To check i opened command prompt and typed in ipconfig/all look for this Then i went to my settings opened the Ethernet tab/change adapter settings Then right clicked Ethernet in network card go to properties I highlighted internet protocol version 4 (tcp/ip4) and select use te following as i set my duet ip address as 192.168.0.31 so i put in one few numbers below Im glad i got it too work as webcontrol user interface is probably best interface ive used to control a printer https://reprap.org/forum/read.php?416,772277,772277#msg-772277 Fri, 17 Apr 2026 12:29:11 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?416,772277,772352#msg-772352 https://reprap.org/forum/read.php?416,772277,772352#msg-772352 dc42 Duet Wed, 07 Jun 2017 17:37:59 -0400 https://reprap.org/forum/read.php?416,772277,772277#msg-772277 https://reprap.org/forum/read.php?416,772277,772277#msg-772277
To check i opened command prompt and typed in ipconfig/all look for this



Then i went to my settings opened the Ethernet tab/change adapter settings
Then right clicked Ethernet in network card go to properties



I highlighted internet protocol version 4 (tcp/ip4) and select use te following as i set my duet ip address as 192.168.0.31 so i put in one few numbers below



Im glad i got it too work as webcontrol user interface is probably best interface ive used to control a printer]]> chris33 Duet Wed, 07 Jun 2017 11:04:52 -0400