FYI: You have to remove the housings of the ribbon cable connectors on the LCD and connect them both in revers in order to make it work. ( revers doesn't mean switch EXP1 with EXP2 ) Alternatively you can cut a notch in the housing. BTW: it works as it should on a RAMPS board but the pinning is the other way round on the Maestro ( eg. EXP1 pin 1 should be 5V, not pin 10 ) Don't want to blame anyone; probably Geeetech just copied the same old error we've seen often with RRD_smart_LCD clones? Q: Can I revers the encoder in RRF? https://reprap.org/forum/read.php?416,841465,841465#msg-841465 Thu, 16 Apr 2026 07:47:41 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?416,841465,841542#msg-841542 https://reprap.org/forum/read.php?416,841465,841542#msg-841542 The RAMPS adapter theory is perfectly plausible.]]> o_lampe Duet Sun, 16 Dec 2018 02:34:20 -0500 https://reprap.org/forum/read.php?416,841465,841487#msg-841487 https://reprap.org/forum/read.php?416,841465,841487#msg-841487 reprap.org]. I purchased two clones of this board on eBay and Amazon, and they both work with the Duet Maestro using the ribbon cables supplied with the controller. However, they did require different settings for the encoder. To configure the encoder, see [duet3d.dozuki.com].

These displays use an adapter board when used with RAMPS, and that adapter is normally supplied with the display. I guess that if they get the display connections wrong, they can correct for it in the adapter.

One of our OEMs also had a problem with the pinout of the displays they purchased. Looks like some of the clone manufacturers didn't copy the original design properly.]]> dc42 Duet Sat, 15 Dec 2018 13:07:54 -0500 https://reprap.org/forum/read.php?416,841465,841465#msg-841465 https://reprap.org/forum/read.php?416,841465,841465#msg-841465 You have to remove the housings of the ribbon cable connectors on the LCD and connect them both in revers in order to make it work. ( revers doesn't mean switch EXP1 with EXP2 )
Alternatively you can cut a notch in the housing.
BTW: it works as it should on a RAMPS board but the pinning is the other way round on the Maestro ( eg. EXP1 pin 1 should be 5V, not pin 10 )

Don't want to blame anyone; probably Geeetech just copied the same old error we've seen often with RRD_smart_LCD clones?

Q: Can I revers the encoder in RRF?]]> o_lampe Duet Sat, 15 Dec 2018 08:55:39 -0500