Hi, My hotend has 2 part cooling fand. They naturally have to work simultaneously. Is it advisable to use a single PWM output on the board for this purposr or should I use a single output by splitting the wire? Also, if splitting is an option, is there a tool/crimp/etc to split a wirein two? I try to wrap 1 wire around the crimp of the second wire but it isn’t very solid of course and can be dislocated. If I use solder to attach the wire to the crimp, it doesn’t fit into the plastic connector housing. Thanks. https://reprap.org/forum/read.php?416,870203,870203#msg-870203 Mon, 12 Oct 2026 05:10:41 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?416,870203,875171#msg-875171 https://reprap.org/forum/read.php?416,870203,875171#msg-875171 i have the same Question, but in my scenario, it dosent work to connect two Fans on one output. (the Board burn)
My question now is how to define it to use two outputs sync.

Unfortunately, these three attempts did not work in the Pin Config.

#define FAN_PIN PC8 & PE5

#define FAN_PIN PC8 and PE5

#define FAN_PIN PC8 + PE5


(I have the SKR Pro V1.1 board)

Greetings, Marta]]> Martalus Duet Sun, 19 Jul 2020 10:24:16 -0400 https://reprap.org/forum/read.php?416,870203,870205#msg-870205 https://reprap.org/forum/read.php?416,870203,870205#msg-870205 dc42 Duet Mon, 06 Apr 2020 02:14:13 -0400 https://reprap.org/forum/read.php?416,870203,870203#msg-870203 https://reprap.org/forum/read.php?416,870203,870203#msg-870203
My hotend has 2 part cooling fand. They naturally have to work simultaneously. Is it advisable to use a single PWM output on the board for this purposr or should I use a single output by splitting the wire? Also, if splitting is an option, is there a tool/crimp/etc to split a wirein two? I try to wrap 1 wire around the crimp of the second wire but it isn’t very solid of course and can be dislocated. If I use solder to attach the wire to the crimp, it doesn’t fit into the plastic connector housing.

Thanks.]]> drmaestro Duet Mon, 06 Apr 2020 01:27:10 -0400