Drilling from the inside with 0.6 lincoln mig tips with a 1/8 bit down towards the end, but guess what every other bit get's so plugged up I cannot clear it by poking something through it's kinda crazy I dunno why but it jams seriously of three tips I attempted only one worked. one other one I lost to a drill bit breaking off and the third I lost to this jam, anything fine enough to fit in the hole from the top is too flexible to clear it anybody have some tricks? thanks in advance for your tips terramir https://reprap.org/forum/read.php?70,113505,113505#msg-113505 Thu, 15 Oct 2026 09:18:20 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?70,113505,120770#msg-120770 https://reprap.org/forum/read.php?70,113505,120770#msg-120770 jcabrer Plastic Extruder Working Group Fri, 24 Feb 2012 20:40:26 -0500 https://reprap.org/forum/read.php?70,113505,119423#msg-119423 https://reprap.org/forum/read.php?70,113505,119423#msg-119423
A sharp drill bit helps too, you'll know it's sharp when you get 2 continuous spirals coming out as you're drilling. If you get little granules, the bit is dull.]]> aplavins Plastic Extruder Working Group Sat, 18 Feb 2012 02:39:42 -0500 https://reprap.org/forum/read.php?70,113505,113517#msg-113517 https://reprap.org/forum/read.php?70,113505,113517#msg-113517 nophead Plastic Extruder Working Group Thu, 12 Jan 2012 11:47:10 -0500 https://reprap.org/forum/read.php?70,113505,113505#msg-113505 https://reprap.org/forum/read.php?70,113505,113505#msg-113505 thanks in advance for your tips
terramir]]> terramir Plastic Extruder Working Group Thu, 12 Jan 2012 10:54:52 -0500