I need the E_STEP_PER_MM value for Wades Extruder...? Thanx MB Edit: oh and how many degrees per step is your motor.... mine is 1.8 oh and my nossle is 0.5mm If your setup differs i can do the math... i just need a base setting... your nossel size and motor's degree spec... Thanks a BUNCH MB https://reprap.org/forum/read.php?70,46892,46892#msg-46892 Wed, 16 Sep 2026 08:09:26 -0400 Phorum 5.2.23 https://reprap.org/forum/read.php?70,46892,51770#msg-51770 https://reprap.org/forum/read.php?70,46892,51770#msg-51770
Calculating E_STEPS_PER_MM for the Reprap Mendel]]> jeffpark_ Plastic Extruder Working Group Thu, 15 Jul 2010 17:39:53 -0400 https://reprap.org/forum/read.php?70,46892,50397#msg-50397 https://reprap.org/forum/read.php?70,46892,50397#msg-50397
Using the spreadsheet is great - but which steps_per_mm do I enter? steps_per_mm of feedstock? or filament?

And the "Ideal Head Feedrate" - This should be entered into the reprap host preferences?

Lastly - how fast should I be capable of extruding?


After experimenting for a while, I can extrude - but very slowly.

Thanks a bunch.]]> t3kboi Plastic Extruder Working Group Wed, 30 Jun 2010 02:25:12 -0400 https://reprap.org/forum/read.php?70,46892,46946#msg-46946 https://reprap.org/forum/read.php?70,46892,46946#msg-46946 Thanks for the info. I guess I over looked it when I was on that page... Thanks a bunch MB]]> Mdbaughman2 Plastic Extruder Working Group Wed, 02 Jun 2010 13:53:22 -0400 https://reprap.org/forum/read.php?70,46892,46929#msg-46929 https://reprap.org/forum/read.php?70,46892,46929#msg-46929
[objects.reprap.org]

There is an xls/ods document that you can punch your numbers into to get the steps/mm for the firmware.]]> jeffpark_ Plastic Extruder Working Group Wed, 02 Jun 2010 10:22:56 -0400 https://reprap.org/forum/read.php?70,46892,46892#msg-46892 https://reprap.org/forum/read.php?70,46892,46892#msg-46892
Edit: oh and how many degrees per step is your motor.... mine is 1.8



oh and my nossle is 0.5mm

If your setup differs i can do the math... i just need a base setting... your nossel size and motor's degree spec...

Thanks a BUNCH MB]]> Mdbaughman2 Plastic Extruder Working Group Wed, 02 Jun 2010 04:19:29 -0400