; Configuration file for RepRap Ormerod 1 ; RepRapPro Ltd ; ; Copy this file to config.g if you have an Ormerod 1. ; If you are updating a config.g that you already have you ; may wish to go through it and this file checking what you ; want to keep from your old file. ; M111 S0 ; Debug off M550 P GreenMachine ; Machine name (can be anything you like) M551 Preprap ; Machine password (currently not used) M540 P0xBE:0xEF:0xDE:0xAD:0xFE:0xED ; MAC Address M552 P192.168.1.14 ; IP address M553 P255.255.255.0 ; Netmask M554 P192.168.1.1 ; Gateway M555 P2 ; Set output to look like Marlin G21 ; Work in millimetres G90 ; Send absolute corrdinates... M83 ; ...but relative extruder moves M906 X800 Y1000 Z800 E800 ; Set motor currents (mA) M92 E428.57143 ; Set extruder steps per mm M558 P2 ; Use an modulated Z probe G31 Z1.90 P570 ; Set the probe height and threshold (deliberately too high to avoid bed crash on setup) M556 S78 X0 Y0 Z0 ; Put your axis compensation here M557 P0 X55 Y0 ; Four... M557 P1 X55 Y175 ; ...probe points... M557 P2 X220 Y175 ; ...for bed... M557 P3 X220 Y0 ; ...levelling ... M201 X800 Y800 Z15 E1000 ; Accelerations (mm/s^2) M203 X15000 Y15000 Z100 E3600 ; Maximum speeds (mm/min) M566 X600 Y600 Z30 E20 ; Minimum speeds mm/minute M563 P0 D0 H1 ; Define tool 0 G10 P0 S-273 R-273 ; Set tool 1 operating and standby temperatures M301 H1 S1.0 T0.67 ;nastavitev za prenizko napetost M574 X0 Y2 Z0 S1 ; set endstop configuration (Y endstop only, at high end, active high)