Hello Kistenschieber
The Ormerod 1 is a great printer, I just love the original design, many
upgrades of the original printed parts has been made over time, these
are a few of my favorite things:
Number 192's new-nozzle-mount
[
forums.reprap.org]
johneato's Control air to the nozzles
[
forums.reprap.org]
dmould's fan deflector
[
forums.reprap.org]
zombiepantslol's Improved Z lower mount ("I decided to replace the
countersunk with regular M4 x 12 cylinder head screws after I noticed
that my original ABS part had broken"
[
forums.reprap.org]
bobtidey's redesigned z nut trap "I also thought the mounting hole on
the nut trap is a bit feeble and does not give much support to the nut
and bolt"
[
forums.reprap.org]
VynZ's One-piece Ormerod bed support "The MDF bed provided with the
Ormerod is too floppy and is better replaced with an aluminium one. The
problem is the complex cut-outs required (usually laser cut) to fit this
on the bed support means that normal people cannot cut this"
[
www.thingiverse.com]
Pointy's X Idler Hub Bracket and Belt Hub
[
forums.reprap.org]
MasonStonehenge's spring-loaded extruder
[
www.thingiverse.com]
iamburny's Extruder Gears
[
www.thingiverse.com]
..or dc42's mod of iamburny's extruder gears (with adjustable hole sizes)
[
www.thingiverse.com]
Thorsen's Extra support for the extruder
[
www.thingiverse.com]
iamburnys Replacement Duet Enclosure "Original part modified for greater
strength and larger holes for power,sd,ethernet, usb also additional
mounting point"
[
www.thingiverse.com]
Pointy's Duet Bed Heater Connector Box Header "Before I fitted my
replacement Duet, I decided to make a simple part to stop the ribbon
cable from being misaligned"
[
forums.reprap.org]
And of cause dc42's brilliant height sensor board
[
miscsolutions.wordpress.com]
..and ditto PanelDue
[
miscsolutions.wordpress.com]
Hardware mods (make the printer stable and transportable):
Selling my Ormerod with many Upgrades and 6 spools of Pla
[
forums.reprap.org]
Ormerod Bigfoot mod!
[
forums.reprap.org]
Merry Christmas all!
Erik