Welcome! Log In Create A New Profile

Advanced

Warmtebed en Printbed

Alles over je MK2a, Kapton of schilderstape. Hier kun je discussieren over de oplossing. 
Page 1 of 1    Pages: 1
Forum List New Topic RSS
Subject Views Posts Last Post

3D-Lac op aluminium ?

by Replace 		1,969 13 05/19/2017 12:58AM
Last Post by Replace

Tip voor het printen op Heatbed (hechten )

by Ton_Crazy 		3,721 23 10/22/2016 03:48AM
Last Post by knaapio

Welk glas ?

by Replace 		960 8 03/18/2016 02:56PM
Last Post by Replace

PEI folie (ook ULTEM genoemd)

by eflin1 		998 3 03/02/2016 02:25PM
Last Post by jonnie

Heatbed isoleren

by sander91 		1,175 8 02/23/2016 12:50PM
Last Post by garaguido

Heated bed 100 graden ipv 55 graden Attachments

by Nsverhagen 		657 7 02/02/2016 02:33PM
Last Post by Wvantoorn

opbouw heatbed

by 19roland70 		547 2 02/02/2016 02:28PM
Last Post by Wvantoorn

Probleem met aansluiting heatbed op megatronics bord

by Koos82 		541 3 07/30/2015 01:13PM
Last Post by Koos82

Autobed leveling Prusa i3

by garaguido 		695 7 04/28/2015 02:56PM
Last Post by garaguido

Heatbed doet het niet

by oopss 		571 6 04/08/2015 01:26PM
Last Post by gforce1

MK3 heatbed aluminium

by sander91 		778 4 01/16/2015 02:19PM
Last Post by SnelleD

Prusa Mendel I2 met Sanguinololu -> Heated Bed? Attachments

by Nsverhagen 		1,091 21 08/23/2014 12:18PM
Last Post by Nsverhagen

kapton 30x30

by Replace 		901 6 08/08/2014 01:41AM
Last Post by gforce1

Kan je kapton nat aanbrengen ?

by Replace 		1,066 6 07/23/2014 04:48PM
Last Post by Replace

Kapton tape 123 inkt.nl

by 3Design 		841 7 07/17/2014 12:36PM
Last Post by 3Design

Heatbed geen hitte ?

by Bennyr 		635 2 07/09/2014 12:03PM
Last Post by jonnie

Printbed   (Pages: 1 2)

by Mechanic 		2,582 42 05/20/2014 11:37AM
Last Post by Ohmarinus
Page 1 of 1    Pages: 1