Welcome! Log In Create A New Profile



Duet is the Arduino Due Compatible RepRap Electronics 
Subject Views Posts Last Post

Support for mixing extruders

by fma
216 2 06/20/2017 05:48AM
Last Post by dc42

Intermittend stepper hickup after cold start

by o_lampe
222 3 06/14/2017 01:34AM
Last Post by o_lampe

Doing action when changing status

by maczar
185 2 06/13/2017 02:14AM
Last Post by dc42

Hot end crashes into second layer

by alangibson
335 6 06/12/2017 09:43AM
Last Post by DeltaCon

(ignore) PC not connecting to new Duet-Ethernet board (windows)

by shadowphile
560 1 06/11/2017 06:33PM
Last Post by shadowphile

4 axis polar geometry

by fma
216 8 06/09/2017 02:29PM
Last Post by fma

Web interface

by fma
229 3 06/09/2017 08:01AM
Last Post by fma

Mixing cartesian and CoreXY config?

by o_lampe
321 14 06/08/2017 07:39AM
Last Post by dc42

Connecting your Duet 0.85 Straight to Computers Ethernet

by chris33
256 2 06/07/2017 05:37PM
Last Post by dc42

RepRapFirmware 1.18 and Panel Due firmware 1.16 released   (Pages: 1 2)

by dc42
1,266 34 06/06/2017 05:09PM
Last Post by dc42

Extruder motor going both forward and backwards on extrude

by ElmoC
316 5 06/04/2017 08:39AM
Last Post by ElmoC

Storing Calibration?

by clearlynotstefan
266 2 06/03/2017 03:50AM
Last Post by dc42

Firmware 1.18.1 and Heater Faults

by DRTak
757 12 06/02/2017 01:23PM
Last Post by dc42
This topic has been moved.


by Italia
    This topic has been moved.

Duet Wifi, two drivers for one 8 wire motor?

by M;kko
238 2 05/29/2017 02:20AM
Last Post by dc42

Mechanical switch for z probe

by chris33
462 10 05/25/2017 05:19PM
Last Post by chris33

M997 S2

by 3D-Print
266 2 05/24/2017 02:26AM
Last Post by dc42

M572 pressure advance for Diamond hotend?

by o_lampe
262 5 05/23/2017 06:17AM
Last Post by dc42

Fan selection?

by clearlynotstefan
390 4 05/23/2017 02:18AM
Last Post by drmaestro

PanelDue STOP not the same as DWC Emergency Stop?

by PDBeal
204 3 05/22/2017 04:12PM
Last Post by dc42

Firmware upgrade

by joestefano
368 9 05/17/2017 04:18AM
Last Post by dougal1957

Fan short!

by clearlynotstefan
244 6 05/14/2017 01:33AM
Last Post by clearlynotstefan

Raspberry Pi as display

by Napalm1432
424 7 05/12/2017 02:26AM
Last Post by o_lampe

just a quick connector question

by chris33
233 3 05/07/2017 04:21PM
Last Post by dc42

(small) Feature request

by unromeo21
280 20 05/07/2017 08:06AM
Last Post by roboprint

Duet 0.6 Burnt EO Heater Ground Now No Web Control Access

by DRTak
255 5 05/05/2017 11:47PM
Last Post by DRTak

Suggested Mosfet for Duet 0.8.5

by Nylkos
431 2 05/02/2017 05:11PM
Last Post by dc42

DUET with IR sensor

by selva_tvi
411 4 05/02/2017 05:00PM
Last Post by dc42

Panel Due brightness control

by JuJuDelta
235 5 04/30/2017 01:29PM
Last Post by JuJuDelta

Probe triggered and don't stop

by DeathmannX
413 7 04/27/2017 12:35PM
Last Post by ElmoC