Welcome! Log In Create A New Profile

Advanced

Heating Element Pros/Cons and Preference

Posted by vulcanrd 
Heating Element Pros/Cons and Preference
December 18, 2011 03:55PM
There are a 3 main different types of heating elements for the extruder that I am seeing are used frequently.

Cartridge Heater - ala Makerbot
Resistor Heater - Hotends.com etc.
Nichrome Wire - Makergear etc.

What is your preference for a heating element and why?
Re: Heating Element Pros/Cons and Preference
December 18, 2011 05:09PM
Resistor because it works just as well as cartridge heater but is much cheaper.

Nichrome works when encased in high temperature thermally conductive cement like Makergear's, but that is hard to get hold of and construction is fiddly.

Edited 1 time(s). Last edit at 12/18/2011 06:09PM by nophead.


[www.hydraraptor.blogspot.com]
Re: Heating Element Pros/Cons and Preference
December 18, 2011 05:45PM
Resistor, hands down.

Nobody seems to be willing to make a small enough cartridge heater for our use, and the reliability/cost of the resistors has been superb.

If the resistors had better dimensional tolerances it would be nice though.


www.Fablicator.com
Re: Heating Element Pros/Cons and Preference
December 18, 2011 09:18PM
Definitely resistor here on the J heads I use work excellent


__________________________________________________________________________
Experimenting in 3D in New Zealand
Sorry, only registered users may post in this forum.

Click here to login