Welcome! Log In Create A New Profile

Anyone Heard of Proto Paradigm?

Iceman086

Anyone Heard of Proto Paradigm?
February 10, 2012 02:28AM

Registered: 13 years ago
Posts: 70

I am considering ordering some 1.75 ABS from Proto Paradign. Has anyone heard of them or bought from them before? If so does their plastic work well?

Proto Paradigm

Thank you,

~Ice

Reply Quote

thekendall

Re: Anyone Heard of Proto Paradigm?
April 09, 2012 10:47PM

Registered: 12 years ago
Posts: 27

Yes, I jsut bought some plastic which came in today. I haven't really looked at it or tried it yet will use it with my makerbot this weekend

Reply Quote

Wraithnot

Re: Anyone Heard of Proto Paradigm?
April 10, 2012 12:29AM

Registered: 12 years ago
Posts: 25

I bought 3 spools of 1.75 mm PLA from them and was very happy with both the plastic and the customer service.

Reply Quote

Dale Dunn

Re: Anyone Heard of Proto Paradigm?
April 10, 2012 11:51AM

Registered: 13 years ago
Posts: 485

I recently started using some 1.75 natural ABS from them. It seems to be working well so far.

Reply Quote

Thav

Re: Anyone Heard of Proto Paradigm?
April 11, 2012 12:36PM

Registered: 13 years ago
Posts: 43

Their blog posts are all very thoughtful and thorough. If that ethic applies even partly to their filament quality I think you'll be good to go. No personal experience though.

Reply Quote

Andrew Diehl

Re: Anyone Heard of Proto Paradigm?
April 11, 2012 03:05PM

Registered: 13 years ago
Posts: 581

I'm 95% sure they use the same plastic supplier as Makerbot and Ultimachine.

www.Fablicator.com

Reply Quote

thekendall

Re: Anyone Heard of Proto Paradigm?
April 26, 2012 02:10AM

Registered: 12 years ago
Posts: 27

My roll of 1.75mm neon green is working just fine on my makerbot the temp I use though is 215 I'm not sure if thermocouple is 100% accurate though.