RepRap Featured in HackaDay
Posted by redskinsjbs
|
Re: RepRap Featured in HackaDay June 03, 2008 03:20AM |
Hi Gene Hacker,
i followed the [email protected] the last year too, but either [email protected] nor reprap can do the finishing - the surface-accuracy is much to coarse
The best try in the actual stage would be lost-cast-moulding with fields metall or lowtemp-wax (which didn't stick to epoxy) and mould with epoxy ...
Viktor
i followed the [email protected] the last year too, but either [email protected] nor reprap can do the finishing - the surface-accuracy is much to coarse
The best try in the actual stage would be lost-cast-moulding with fields metall or lowtemp-wax (which didn't stick to epoxy) and mould with epoxy ...
Viktor
|
Re: RepRap Featured in HackaDay June 20, 2008 07:50AM |
... an update for 3D-stacking chess-pieces:
Milled from 3mm Foamalux, total height 4cm.
Actually my sons insist in building 'personalized' figurines for their favorite boardgames - when i'll do this, it would mean some months designing and milling
Viktor
Milled from 3mm Foamalux, total height 4cm.
Actually my sons insist in building 'personalized' figurines for their favorite boardgames - when i'll do this, it would mean some months designing and milling
Viktor
|
Re: RepRap Featured in HackaDay June 20, 2008 04:51PM |
... i've designed a complete set of stacked pieces:
If someone is interested in milling or fabbing them i'll append the DXF-output and when converted for my mill there would be optimized DXF, HPGL or NCP ... i'm searching a GCode-converter ...
Viktor
If someone is interested in milling or fabbing them i'll append the DXF-output and when converted for my mill there would be optimized DXF, HPGL or NCP ... i'm searching a GCode-converter ...
Viktor
|
Re: RepRap Featured in HackaDay June 25, 2008 02:25PM |
... and here the milled set of mini-pieces:
I used a sample-sheet of laminate with 0.8mm thickness and milled with a 1mm-head.
Viktor
I used a sample-sheet of laminate with 0.8mm thickness and milled with a 1mm-head.
Viktor
|
Re: RepRap Featured in HackaDay September 06, 2008 03:03PM |
... update - my youngest son wanted a flower for his butterfly, so i milled a flower-chip with the same parameters.
...flower in pieces:
... and assembled:
Viktor
...flower in pieces:
... and assembled:
Viktor
|
Re: RepRap Featured in HackaDay September 19, 2008 03:48PM |
... now the other evolved to 3D-chips.
DarthVaders mask (milled from black POM and floor-laminate):
Viktor
DarthVaders mask (milled from black POM and floor-laminate):
Viktor
Sorry, only registered users may post in this forum.