Hi to all on the forum,
I'm getting reliable prints from my printer.......but...
1 thing is still not working out. Although it doesn't seem to cause any structural problems, the inside perimeters on any holes printed doesn't stick very well. After reaming, a lot of it comes out which is annoying as the prints overall are good. Pic attached.
I am using Slic3r with PLA filament, 2 perimeters and have the perimeter speeds set at 20mm a second.
Any thoughts?
Thanks
Raj
Attachments:
open |
download -
2012-04-14_13.00.39.jpg
(393.9 KB)