Now that I worked out my RAMPS firmware issue, I'm having a bit of difficulty with getting it to communicate with the RepRap Host Software.
It works fine with RepSnapper but I can't seem to get it to respond to commands via RepRap Host.
I've changed my BaudRate to match the firmware.
I've changed the port name to COM13 (where the mega is installed)
Other settings I'm not sure if they matter:
Extrude 0 Address=0
Shield =False
FiveD=False
Not sure how to get it to communicate. There isn't a "connect to printer" button like RepSnapper has is there? Once again, I'm sure this is an easy fix, I'm just over looking something. Thanks!