RepRap Logo files
Posted by spacexula
|
Re: RepRap Logo files April 10, 2010 03:17AM |
1. In any RepRap wiki page enter "logo" into the search field and click the search button.
2. Scan the list of results for "RepRapLogo" and click on the hyperlink.
3. Click on the logo.
4. Click on the "Full resolution" hyperlink.
P.S. Have attached an SVG file (created using InkScape from PNG file).
If I can find out what font is being used then I can get it exact then you will have a scalable RepRap logo.
InkScape can then export it as a PNG in any resolution that you may need.
Edited 4 time(s). Last edit at 04/10/2010 04:42AM by rhmorrison.
Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse
2. Scan the list of results for "RepRapLogo" and click on the hyperlink.
3. Click on the logo.
4. Click on the "Full resolution" hyperlink.
P.S. Have attached an SVG file (created using InkScape from PNG file).
If I can find out what font is being used then I can get it exact then you will have a scalable RepRap logo.
InkScape can then export it as a PNG in any resolution that you may need.
Edited 4 time(s). Last edit at 04/10/2010 04:42AM by rhmorrison.
Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse
|
Re: RepRap Logo files July 25, 2010 09:53AM |
Has anyone come up with a high resolution logo file yet? I'm trying to do the same thing that spacexula was doing a few months ago.
If not, does anyone know what font is used?
rhmorrison Wrote:
-------------------------------------------------------
> 1. In any RepRap wiki page enter "logo" into the
> search field and click the search button.
> 2. Scan the list of results for "RepRapLogo" and
> click on the hyperlink.
> 3. Click on the logo.
> 4. Click on the "Full resolution" hyperlink.
>
>
> P.S. Have attached an SVG file (created using
> InkScape from PNG file).
> If I can find out what font is being used then I
> can get it exact then you will have a scalable
> RepRap logo.
> InkScape can then export it as a PNG in any
> resolution that you may need.
Darwin clone, Gen 2 electronics, Arduino Duemilanove w/ AtMega328, 5D Firmware, Pinchwheel extruder
[www.codeerrors.com]
If not, does anyone know what font is used?
rhmorrison Wrote:
-------------------------------------------------------
> 1. In any RepRap wiki page enter "logo" into the
> search field and click the search button.
> 2. Scan the list of results for "RepRapLogo" and
> click on the hyperlink.
> 3. Click on the logo.
> 4. Click on the "Full resolution" hyperlink.
>
>
> P.S. Have attached an SVG file (created using
> InkScape from PNG file).
> If I can find out what font is being used then I
> can get it exact then you will have a scalable
> RepRap logo.
> InkScape can then export it as a PNG in any
> resolution that you may need.
Darwin clone, Gen 2 electronics, Arduino Duemilanove w/ AtMega328, 5D Firmware, Pinchwheel extruder
[www.codeerrors.com]
|
Re: RepRap Logo files November 18, 2012 09:38AM |
Sorry, only registered users may post in this forum.