Welcome! Log In Create A New Profile

nothing's coming out!

[email protected]

nothing's coming out!
February 03, 2013 07:58PM

Registered: 11 years ago
Posts: 33

I got my temperature set to 230.and the filament is going in to the hotend., but very little is coming out. when I pull the filament back out, it's kinda crunched up, and the end is a little bit wider... what's wrong? what else could I need to change?

Reply Quote

Attachments:
open | download - 2013-02-03_18-47-53_847a.jpg (219.4 KB)

dissidence

Re: nothing's coming out!
February 03, 2013 08:05PM

Registered: 14 years ago
Posts: 800

what hot end are you using,

you have a gap just above your hot end.

[mike-mack.blogspot.com]

Reply Quote

[email protected]

Re: nothing's coming out!
February 03, 2013 08:26PM

Registered: 11 years ago
Posts: 33

a 'j-head' style Hot-end, .5 extrusion tip

Reply Quote

jamesdanielv

Re: nothing's coming out!
February 03, 2013 08:30PM

Registered: 13 years ago
Posts: 1,797

i cant tell what is the feedstock size 3m or 1.75mm?

Reply Quote

[email protected]

Re: nothing's coming out!
February 03, 2013 08:32PM

Registered: 11 years ago
Posts: 33

1.75

Reply Quote

Polygonhell

Re: nothing's coming out!
February 03, 2013 08:36PM

Registered: 11 years ago
Posts: 939

From the picture, it looks like it's getting buckled probably between the cold end and the hot end, is the Hotend seated all the way into the cold end assuming you have a wades style cold end.

Reply Quote

Knimrod

Re: nothing's coming out!
February 03, 2013 08:44PM

Registered: 11 years ago
Posts: 40

Any chance you are using 1.75mm filament in a 3mm hot end?

ΜΟΛΩΝ ΛΑΒΕ

Reply Quote

[email protected]

Re: nothing's coming out!
February 03, 2013 08:45PM

Registered: 11 years ago
Posts: 33

that I couldn't tell ya? all I know is it's some sort of plastic tube? with a metal tip, the heater and thermosistor are in the tip....

Reply Quote

Attachments:
open | download - 2013-02-03_19-36-29_288a.jpg (101.2 KB)

[email protected]

Re: nothing's coming out!
February 03, 2013 09:25PM

Registered: 11 years ago
Posts: 33

that I also don't know. I was looking at that piece of filament, and in the center it looks wider, but I'm confused as to how that would have melted but not the filament below it, closer to the heater? is there any point in a 1.75 hot end that would be wider? (I bought the hot end assembled, so I'm not so sure of the inner workings of it)....