Hi
I have completed building my Prusa Air2 and have the Sanguinololu Board with marlin 1.0 preloaded.
I can connect to the printer but the problem I have is when I click on the Home button ( Pronterface ) on X,Y,Z axis, the motors move a small amount and don't move all the way to the end stops. The small movement is in the correct direction.
Could this be due to a setting in marlin that needs changing ?
Would I be able to see the Pre-loaded Marlin settings or do I have to Flash the board again with new settings ?
Thanks
I would appreciate some advice, thanks
Vaughan