Last decision on a Printer

So I think this will be my last post on deciding on a printer. My 2 choices I have right at the moment or I'm looking in is the Huxley and the Printrbot LC V2. I'm looking into a cheap 3D Printer with a big Printbed. But I can't really find any Printrbot LC V2 reviews, and I also was looking into a Prusa I2, but I can't find a store online that ships to canada, or has plastic parts like a full kit.

Has anybody had experience with this model?

[romscraj.com]

it looks good, its just a variant of the prusa i2, and its a good little printer, probably the most common at this point, the mendel max has a larger bed, but it costs more, but its much stronger and easier to build in my opinion. dont forget the mendel90 [forums.reprap.org]

Quote

I'm looking in is the Huxley [...] with a big Printbed.

Huh? Huxley is one of the smallest designs available. If you make it bigger, you get a Mendel.

---

Generation 7 Electronics	Teacup Firmware	RepRap DIY

I think I didn't write that properly... Sorry.