Help with Mondo

Hi all, newbie here!

I purchased a reprap mondo kit that comes with what I believe is a techzone monotronics. I finished building the machine and have "calibrated" the current of the motors by touching it. I have also been able to use the arduino/sanguino software to connect to the monotronics and upload a firmware to it, but I am not able to make repsnapper, replicatorG nor reprap host to "see" the printer via USB and of course I can´t send commands to the board or prints of any kind. This is my first printer and I am somewhat confused about what can I do now.

For another project, I have now available a RAMPS 1.4 board with its motor drivers and a mega 2560, it is advisable to use it to try to connect the mondo and if it works, can I asume the monotronics is bad? or should I stick with the monotronics?

Any help will be very appreciated.

Thanks, Daniel

HI! seems the reprap mondo is pretty rare but yeah im a newbie too, and id recommend 'pronterface' hope youre still active!

Thank you!

Several months ago, I changed the electronics to RAMPS, and I printed more or less well (learning a lot in the process) since I sell the Mondo some weeks ago to someone that wanted a working printer rather than build one himself, I did some modifications to the original design and parts so, I gave him a better printer than a plain Mondo.

Right now, I am building (finishing) my own design and I am about to start selling them.

Thanks a lot for your message.