print head colliding July 08, 2012 02:29PM |
Registered: 12 years ago Posts: 82 |
Re: print head colliding July 08, 2012 02:35PM |
Registered: 14 years ago Posts: 177 |
Re: print head colliding July 08, 2012 02:49PM |
Registered: 14 years ago Posts: 689 |
Re: print head colliding July 09, 2012 10:59AM |
Registered: 16 years ago Posts: 824 |
Re: print head colliding July 09, 2012 03:10PM |
Registered: 12 years ago Posts: 82 |
Yes it is consistentQuote
Does your Z axis move correctly?
and accurate.Quote
Have you calibrated your Axes, and the extruder?
I have tried to avoid this (extra time & blobs.)Quote
Turn on lift/hop to lift the z axis while moving.
Quote
Add a fan to cool down the part faster so the plastic doesn't curl up.
PLA yes, Using a fan causes my prints to detach from the bed.Quote
If you are printing with PLA (not ABS), and you don't have a fan, get one.
I suppose but prints take long enough as it is.Quote
Slow down acceleration and/or travel speed so if the z should catch on, it's at least with less force.
Speed again, individual small parts take a long time as you need to wait for each layer to cool.Quote
Print several small parts sequentially. (Advanced tab in Slic3r).
Re: print head colliding July 09, 2012 04:02PM |
Registered: 14 years ago Posts: 689 |
Re: print head colliding July 09, 2012 10:51PM |
Registered: 14 years ago Posts: 177 |
Re: print head colliding July 10, 2012 02:38AM |
Registered: 11 years ago Posts: 44 |
Re: print head colliding July 10, 2012 06:23AM |
Registered: 11 years ago Posts: 31 |
Re: print head colliding July 10, 2012 07:40AM |
Registered: 11 years ago Posts: 33 |
Re: print head colliding July 10, 2012 07:49AM |
Registered: 14 years ago Posts: 177 |
Re: print head colliding July 10, 2012 07:59AM |
Registered: 11 years ago Posts: 33 |
Re: print head colliding July 19, 2012 03:47AM |
Registered: 12 years ago Posts: 82 |