configure skeinforge to use a 0.35mm nozzle
July 14, 2012 08:53AM
Hello

I want to usr a 0.35mm nozzle to have more detailed prints but i can't find that configuration in skeinforge.

I tryied printing with the same values of my 0.5mm nozzle but with a layer heigth changed from 0.3 to 0.2mm in carve section.

Thank you


Ernesto Pareja

dcctrains.netne.net
Re: configure skeinforge to use a 0.35mm nozzle
July 14, 2012 09:32AM
Skeinforge doesn't need to know the size of the nozzle. You just have to use appropriate layer heights and filament widths. I am using 0.2mm layers and 1.5 W/T for PLA through a 0.35mm J_head. If you have W/T bigger the layer would need to be lower.


[www.hydraraptor.blogspot.com]
Sorry, only registered users may post in this forum.

Click here to login