Welcome!
Log In
Create A New Profile
Home
>
General
> Topic
Advanced
Dissolving pla with Methylene Chloride ?
Posted by
Nikki81
Forum List
Message List
New Topic
Nikki81
Dissolving pla with Methylene Chloride ?
June 15, 2015 12:06PM
Registered: 9 years ago
Posts: 198
How long should a soak my nozzles for I've had them in for a few hours now and I am not sure it's working.
Edited 1 time(s). Last edit at 06/15/2015 12:07PM by Nikki81.
Reply
Quote
Nikki81
Re: Dissolving pla with Methylene Chloride ?
June 16, 2015 05:05AM
Registered: 9 years ago
Posts: 198
I did a bit of testing last night and found that 1 Methylene Chloride is horrible nasty stuff and 2 it had only taken a few minutes to clean them up and they just needed a rinse and a wipe.
Reply
Quote
o_lampe
Re: Dissolving pla with Methylene Chloride ?
June 16, 2015 05:57AM
Registered: 8 years ago
Posts: 5,232
Nasty? Yes, even latex gloves are not enough for protection.
But useful, too
-Olaf
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login