This is my second print.

The first layer turned out ok. The second layer failed and detached from the bed. I think the nozzle could have been too fast, too low or too much pla. I am leaning towards too fast but not sure. I think its mainly the infill that was too quick. Do I change the infill or solid infill speed in slicer? The second layer also had a big dip in it. Not sure what this means. Looks like it happens either the infill starts or stops...

Marlin 1.5, pronterface
Nozzle .5
PLA 1.75

Looks like your e_steps is too high so it extrudes too much plastic.

---

--
-Nudel
Blog with RepRap Comic