Dual X (Or Y) Motors?

Hello all,

I am currently having a go at my own DIY RepRap 3D Printer.

My design however uses x2 X Motors.

I am using a Rambo controller board and that has x1 X Motor, x1 Y Motor and x2 Z motor headers.

Am I right in thinking that if I swap the pin definitions in Marlin I can turn the Original Z motor headers into X headers, and the single X into the Z header?

I hope someone can help me on this one!

Regards,

Alex

Yes you can swap them like that

Just update the 3 pin definitions for enable, step and direction.