extruder cooling and full graphic smart controller assistance
Posted by ha8rd
|
extruder cooling and full graphic smart controller assistance January 19, 2018 03:33AM |
hey guys
It does not start with the Trigorilla panel, so the extruder is cooled. There is a repetier toolson firmware. I built a I3steel toolson printer.
What do you recommend in the setup instead of the fan pin6???
display setting this does not work
thanks Laci
It does not start with the Trigorilla panel, so the extruder is cooled. There is a repetier toolson firmware. I built a I3steel toolson printer.
What do you recommend in the setup instead of the fan pin6???
display setting this does not work
thanks Laci
Sorry, only registered users may post in this forum.