Control 4 steppers with Arduino Uno/Due and CNC Shield September 19, 2018 05:44PM |
Registered: 8 years ago Posts: 4 |
Re: Control 4 steppers with Arduino Uno/Due and CNC Shield September 19, 2018 08:52PM |
Admin Registered: 13 years ago Posts: 6,995 |
Re: Control 4 steppers with Arduino Uno/Due and CNC Shield September 20, 2018 05:12AM |
Registered: 8 years ago Posts: 4 |
Re: Control 4 steppers with Arduino Uno/Due and CNC Shield September 20, 2018 06:59AM |
Admin Registered: 13 years ago Posts: 6,995 |
Re: Control 4 steppers with Arduino Uno/Due and CNC Shield September 20, 2018 07:51AM |
Registered: 8 years ago Posts: 4 |
Quote
Dust
On the breadboard the enable line to the stepper driver is not pulled low, so it is not enabled.
Same with the Shield EN and GND need to be connected with jumpers, or you can connect EN to the controller an turn it on with software
Re: Control 4 steppers with Arduino Uno/Due and CNC Shield September 20, 2018 12:34PM |
Admin Registered: 13 years ago Posts: 6,995 |