Hey there again,
I am currently experimenting with my second nozzle which has been unused since I finished my setup.
I am using PrusaSlicer which has a setting to retract the inactive tool by a variable value.
Unfortunately it will only do so on the first tool change but not on the beginning of a print which will cause the unused nozzle to droop until the first tool change is done.
Has anyone found a workaround for this? I know that Slic3r / PrusaSlicer support conditions in the custom gcode section but I don't know how this might help me.
I am looking for a solution that works for either extruder (no matter whether the first one or the second one is inactive from the start)
Any help is much appreciated.