Welcome! Log In Create A New Profile

Best introduction-to-3d-print video yet

Stromgren

Best introduction-to-3d-print video yet
September 28, 2012 03:09PM

Registered: 14 years ago
Posts: 7

I just stumpled upon this video and i thought it was worth sharing.

[www.youtube.com]

I hope i'm not like the 20th guy to share this winking smiley

Reply Quote

DeuxVis

Re: Best introduction-to-3d-print video yet
September 28, 2012 03:40PM

Admin
Registered: 14 years ago
Posts: 2,569

Looks a lot like an advertisement to me.

Most of my technical comments should be correct, but is THIS one ?
Anyway, as a rule of thumb, always double check what people write.

Reply Quote

rhmorrison

Re: Best introduction-to-3d-print video yet
September 28, 2012 04:07PM

Registered: 16 years ago
Posts: 3,742

And an idiot that likes to touch hot things - eye rolling smiley

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse

Reply Quote

Beekeeper

Re: Best introduction-to-3d-print video yet
September 28, 2012 04:13PM

Registered: 14 years ago
Posts: 115

He should show Cathy Lewis (from 3D Systems) how to use hers. The Cube at TCT2012 show didn't produce very good prints. Check out Richrap's Blog for more info.

Reply Quote

MattMoses

Re: Best introduction-to-3d-print video yet
September 28, 2012 06:04PM

Admin
Registered: 15 years ago
Posts: 730

I think this introduction to Reprap Prusa Mendel by OhmEye is very good.

Reply Quote

Stromgren

Re: Best introduction-to-3d-print video yet
September 28, 2012 06:26PM

Registered: 14 years ago
Posts: 7

DeuxVis Wrote:
-------------------------------------------------------
> Looks a lot like an advertisement to me.

No, it was more meant like joke smiling smiley

Reply Quote

anode505

Re: Best introduction-to-3d-print video yet
October 05, 2012 06:35AM

Registered: 15 years ago
Posts: 99

Beekeeper Wrote:
-------------------------------------------------------
> He should show Cathy Lewis (from 3D Systems) how
> to use hers. The Cube at TCT2012 show didn't
> produce very good prints. Check out Richrap's Blog
> for more info.

3DSystems can't get out of their own way. They deseve ALL the bad karma they can muster.