Hi guys, I really need some help, I have a low end printer that I managed to short out the main board, I purchased a new board (bigtree MKS Gen V1.4, Mega 2560 R3, Reprap Ramps 1.4). I have installed the board, hooked up all wiring, I ordered and recieved 5 stepper drivers, as far as I can see they just push in to the board, which way do they go in , it looks like they could be installed 180 degrees either way ? They are the 2560 type.
Also could you advise me on start up, once everything is hooked up do I just turn it on, flash the config h. and go , or is there more to be done first.
I would really appreciate any help you can offer.
Thanks
Terry