Webcam anyone?

Here is my webcam streaming whatever my printer is doing [tinyurl.com]
Anyone else got one on their printer?

---

_________________________________________________________________________________________

Richmond, New Zealand
Thingiverse ~ YouTube

Yes I did for a while, but I thought it was causing crashes : ). Aatually, found out later that switching the fan on (for tall builds) causes a surge into the ATC which choked the RAMPS controller somehow! Weak.

Edited 1 time(s). Last edit at 10/10/2012 12:49AM by Simba.

I had a phantom crasher for a while. The printer would be workling fine then I would leave the workshop and go back to the house and come back to find it had stopped when I left the room. Tracked it down to the computer crashing everytime I turned the fluorescent lights on or off. So now I print from SD card only and it doesn't matter if the computer crashes.
I put the webcam up so I could check on the printer on the Ipad from the lounge room watching a movie or a game

---

_________________________________________________________________________________________

Richmond, New Zealand
Thingiverse ~ YouTube