Welcome! Log In Create A New Profile


Prusa i2 BOM error?

Posted by Kingdomfire 
Prusa i2 BOM error?
October 18, 2012 01:08PM
Hi all, Just ordered all the parts to my Prusa i2, followed the wiki BOM (I2 BOM) and it states 6 lengths of 405mm smooth rod. Also the threaded rod lengths seem incorrect?

Just come to the build page and noticed the lengths have been changed. (Prusa I2 Build)

Didn't know who to tell so it could be adjusted so thought i'd post on here? Also didn't want anyone else to get caught out by it.


Re: Prusa i2 BOM error?
October 18, 2012 01:35PM
Hey Tom!

Wiki is a community effort which can be changed by anyone, so apparently someone updated one page without updating both. This happened when I built the Printrbot. What I did was assemble the best I could and adjust from there and the changes became obvious. If you find out which one is "better" or more accurate to the length needed you can always make the changes to the wiki yourself.

Re: Prusa i2 BOM error?
October 18, 2012 02:22PM
Cool! Thanks Tom, :-) I will continue with my build and then go back to the Wiki pages and edit as I think it requires.

Sorry, only registered users may post in this forum.

Click here to login