Welcome! Log In Create A New Profile


advise needed

Posted by ceviz 
advise needed
January 03, 2013 09:35AM
Hey all,

i had this topic in electronics folder but no reply made, hence i thought maybe having it here may help.

i burnt the microcontroller of my orca v0.3 gen6 card (the card touched the metal frame while working).then tried to use my old gen6 from my previous orca v0.2 and managed to establish the connection, z axis is controlled, extrusion is controlled properly, but x and y axises are moving only in one direction and that direction is wrong. (going minus when supposed to be plus). when i click on the opposite direction, not moving at all, even though kinda light noise is coming from the motor.

i tried to upgrade the card by using the link below, which i did previously when i bought the card that i burnt and it worked. [makemendel.com]

is there anyone who could give me some suggestions?

thanks in advance for your help.
Re: advise needed
January 03, 2013 11:32AM

- akhlut

Just remember - Iterate, Iterate, Iterate!

Sorry, only registered users may post in this forum.

Click here to login