are these motors good for a reprap?

Hello everyone, I'm new in the forum and would like to ask you a question:
I have four of these motors arising from a project done in the past, I was wondering if it would be good to make a RepRap, I thought like Prusa i3.
Resistance is a bit 'high, not the best for extreme microstepping, but the couple is good.
My first idea would be to use them with a RAMPS, because I already have some Pololu drivers and one arduino mega.
Thank you all.

[www.watterott.com]

They'll be fine, they might run a little hot, since you're going to be running close to their rated power.

On this note, make sure not to turn up your Polulus too much - from the numbers, can fry these motors before
the current limiting takes effect - especially if you were to have heatsinks on the Polulus.

My idea would be to adjust the Pololu to 1 amp from his trimmer, which is also the limit beyond which the driver itself must be cooled.