Welcome! Log In Create A New Profile


Software to Load

Posted by scubi 
Software to Load
February 08, 2013 04:29AM
Ok I am finished building my Reprap Air 2 printer and this is what I have. Have not switched anything on yet. The hotbed has been assembled aswell. I have the Greg's hinge extruder with the J-Hot head (0.5mm ) Bought some 3mm filament.

1. Sanguinololu Board and was told that the firmware has been loaded.
2. Windows 7

Please can you tell me what software do I load to start with the setting up and then printing.
Is the sequence of loading the software and if there is , whats is it.
I don't know linux code. I know there plenty info on this, if you don't mind with the steps.

Sorry, only registered users may post in this forum.

Click here to login