HI
Ok I am finished building my Reprap Air 2 printer and this is what I have. Have not switched anything on yet. The hotbed has been assembled aswell. I have the Greg's hinge extruder with the J-Hot head (0.5mm ) Bought some 3mm filament.

1. Sanguinololu Board and was told that the firmware has been loaded.
2. Windows 7

Please can you tell me what software do I load to start with the setting up and then printing.
Is the sequence of loading the software and if there is , whats is it.
I don't know linux code. I know there plenty info on this, if you don't mind with the steps.

Thanks