Hi,
I have just setup my reprappro Huxley and are currently experiencing some print troubleshooting. I have attached an image in this thread.
The large one is he austere bunny from thingiverse and the square wall is the .5mm wall from the calibration instructions.
I find that as he printer prints a few layers, it starts to offset itself thus printing slipped layers.
I found that with the wall print, when there was no infill, it printed fine and didn't slip.
I am using the last eat slic3r plugin. I heard a few speculations around loose y axis belts?
What do you guys think?
Thanks!
Rui