Hi,


I have just setup my reprappro Huxley and are currently experiencing some print troubleshooting. I have attached an image in this thread.

The large one is he austere bunny from thingiverse and the square wall is the .5mm wall from the calibration instructions.

I find that as he printer prints a few layers, it starts to offset itself thus printing slipped layers.
I found that with the wall print, when there was no infill, it printed fine and didn't slip.

I am using the last eat slic3r plugin. I heard a few speculations around loose y axis belts?

What do you guys think?


Thanks!
Rui

what are your slic3r speed settings?

have you tried reducing flow rate

Edited 1 time(s). Last edit at 02/21/2013 03:02AM by jamesdanielv.

Probably loose pulley on the axis where it's missing steps.

Could also be binding, loose belts, too high acceleration, overheating stepper drivers or motors.

---

--
-Nudel
Blog with RepRap Comic