Welcome! Log In Create A New Profile

using kislicer

tattooedfish

using kislicer
March 13, 2013 04:51PM

Registered: 10 years ago
Posts: 161

Hey guys kislicer is just a stl/gcode handler.with a visual user interface I still have to.use pronterface to handle the code ?

Reply Quote

Sublime

Re: using kislicer
March 13, 2013 05:00PM

Registered: 12 years ago
Posts: 2,947

Yes or Repitier host or Sender.py or RepSnapper or even a serial terminal.

Edit: Or add SD support on the machine and eliminate communication errors and not need to have the machine connected to a computer at all.

Edited 1 time(s). Last edit at 03/13/2013 05:01PM by Sublime.

FFF Settings Calculator	Gcode post processors	Geometric Object Deposition Tool Blog
Tantillus.org	Mini Printable Lathe	How NOT to install a Pololu driver

Reply Quote

tattooedfish

Re: using kislicer
March 13, 2013 05:50PM

Registered: 10 years ago
Posts: 161

OK check can anyone tell me why my models show up in the center of the bed on kislicer but once its imported into peonterface it is not even on the board but off to the side sorry for the dumb questions hut I'm still anewb at this stuff

Reply Quote

Sublime

Re: using kislicer
March 13, 2013 06:28PM

Registered: 12 years ago
Posts: 2,947

It may be the settings under printer in kisslicer are not correct for your machine or it may be pronterface not liking the comments in the file (try turning off comments).

FFF Settings Calculator	Gcode post processors	Geometric Object Deposition Tool Blog
Tantillus.org	Mini Printable Lathe	How NOT to install a Pololu driver

Reply Quote

Spk64

Re: using kislicer
March 13, 2013 08:16PM

Registered: 10 years ago
Posts: 79

I think it may be in the printer setup tab. I had to add 100 x 100 offset to x and y to center my prints.
Also either add gcode to home before printing or home each axis in pronterface before each print. Easier to make the add in kisslicer so each file already homes the axis.