what are the must have printed parts for a reprap?

Hey guys my prints are slowly but surely getting better honestly I think my major problem is the filament has a lot of air bubbles anyway I want to know what innovative/cool things you have printed for reprap to improve overall print quality and make life easier?

I've seen a few cool design ideas on thingiverse but looking for more direct feedback of what made u decide to print the part? Did it work as u expected and make things easier? What flaws or issues did u run into with the original machine design?

Edited 1 time(s). Last edit at 03/15/2013 04:05PM by tattooedfish.

oops.. wrong thread

Edited 1 time(s). Last edit at 03/15/2013 09:10PM by DaGroundZero.

Follow the thread of extruder upgrades on thingiverse starting with my original greg's wade. Each update usually came with a description of what improvements were made. Start here [www.thingiverse.com]
You might also want to look at my X ends (the screw adjustable z stop depressor was a useful addition).

Greg Frost Wrote:
-------------------------------------------------------
> Follow the thread of extruder upgrades on
> thingiverse starting with my original greg's wade.
> Each update usually came with a description of
> what improvements were made. Start here
> [www.thingiverse.com]
> You might also want to look at my X ends (the
> screw adjustable z stop depressor was a useful
> addition).


OK thanks I will look at that