Welcome! Log In Create A New Profile

Advanced

pronterface not taking commands

Posted by coreformula 
Forum List Message List New Topic
coreformula
pronterface not taking commands
March 23, 2013 03:48PM
When I enter M503 into pronterface, I am assuming that it will will spit out a bunch of output, including: Maximum acceleration & Maximum feed rate.

The only thing that happens is that it says "SENDING M503"

I am using the most current version of pronterface for Win.
Reply Quote
Komb'
Re: pronterface not taking commands
March 23, 2013 03:53PM
What firmware is the printer using?

Pronterface looks to be sending the command out, which is its job. Then it mush wait for the printer to respond.

Komb'
Glankonian Protoforms
Reply Quote
coreformula
Re: pronterface not taking commands
March 23, 2013 04:00PM
Firmware is marlin
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login