Welcome! Log In Create A New Profile


heatbed holes

Posted by chris33 
heatbed holes
May 23, 2013 01:25PM
I am wondering is it possible to make the holes larger on a heatbed so i can use m4 bolts as my i3 y plate holes are tapped out to m4. I was going for a standoff with a spring to fit over it(for bed leveling purposes) but don't want to get custom made standoffs m4 male to m3 female, it be easier if i can make the holes bigger?
Re: heatbed holes
May 23, 2013 02:16PM
They are very close to edge so I think there is a fair chance they would break out while being drilled.

Re: heatbed holes
May 23, 2013 03:27PM
yes i seen looks like i will get someone at work to make me a set of custom stand offs
Sorry, only registered users may post in this forum.

Click here to login