Is this PTFE liner ok?
Posted by Gibbedy
|
Is this PTFE liner ok? July 21, 2013 08:19AM |
I can't get extrusion as consistent as I'd like at different feed rates.
I pulled my hotend off and found the grub screw holding the ptfe liner cranked up very, very tight.
Is this deformed and need replacing?
edit: Jhead MKIV-B
Edited 1 time(s). Last edit at 07/21/2013 08:19AM by Gibbedy.
I pulled my hotend off and found the grub screw holding the ptfe liner cranked up very, very tight.
Is this deformed and need replacing?
edit: Jhead MKIV-B
Edited 1 time(s). Last edit at 07/21/2013 08:19AM by Gibbedy.
Sorry, only registered users may post in this forum.