Fan size on G3D Ramps-cooling plate

Hi guys, can anyone tell me what size of fan they use on this product?
[gadgets3d.eu]


I have been all over the web and can't find out. Also, haven't heard anything back from my message yet so I wonder if anyone already has ordered it and what size it has

They look to be on top a Arduino/RAMPS which would make them 40 mm fans
Edit, 17 fans, that's a lot of fans

Edited 1 time(s). Last edit at 08/11/2013 05:09PM by Myles.

with that i could have some fans...lol im done with the bad puns.

nice idea. though i will say that i would like this with some manual controle for a row for things that i dont want tied to the cooling fan output.

Myles Wrote:
-------------------------------------------------------
> They look to be on top a Arduino/RAMPS which would
> make them 40 mm fans
> Edit, 17 fans, that's a lot of fans



Well, I have put my measuring tool over the image and over the real ramps I have here and it looked more like 50x50 or 60x60 because it's a bit wider.

Dissidence, what do you mean with:
"though i will say that i would like this with some manual controle for a row for things that i dont want tied to the cooling fan output" ??

i use a few fans but i like to have them bloweing at different speed, like for my hot end vs one that is blowing on my prints, and another one that is plowing on my ramps board, i dont have them all set at the same speed.

Well it says in the explanation:
"G3D Fan Splitter let you to connect up to 17 fan coolers/LED's and contain 2x PWM output."

So you get 2x PWM output.

And wasn't there already PWM on the Ramps?

I'd really recommend just using 1 larger fan rather than 2 small ones. You will get much lower noise at the same airflow.

I can confirm it's 50x50mm I have received the package in the mail yesterday and just wanted to confirm it here.

Nice and simple part, when I have the fan splitter I'll let you guys know how it performs.