Command to increase hotend current/power?
Posted by nechaus
|
Command to increase hotend current/power? August 14, 2013 08:50PM |
Registered: 13 years ago Posts: 313 |
Hey guys, I have been searching and cant seem to find the command to enter to increase the current to the hot end.
I remember reading somewhere a command to put in pronterface to increase the current and overall power to the hotend ?
Iv got gen 6, marlin, i noticed when using a fan on the top part of my hotend, it really struggles to maintain its temp....
Edited 1 time(s). Last edit at 08/14/2013 08:51PM by nechaus.
I remember reading somewhere a command to put in pronterface to increase the current and overall power to the hotend ?
Iv got gen 6, marlin, i noticed when using a fan on the top part of my hotend, it really struggles to maintain its temp....
Edited 1 time(s). Last edit at 08/14/2013 08:51PM by nechaus.
|
Re: Command to increase hotend current/power? August 14, 2013 08:53PM |
Registered: 14 years ago Posts: 809 |
Have you autotuned the nozzle with the fan running?
- akhlut
Just remember - Iterate, Iterate, Iterate!
[myhomelessmind.blogspot.com]
- akhlut
Just remember - Iterate, Iterate, Iterate!
[myhomelessmind.blogspot.com]
|
Re: Command to increase hotend current/power? August 14, 2013 08:57PM |
Registered: 15 years ago Posts: 1,797 |
you can look at standard gcode wiki here: [reprap.org]
there is an extruder pwm command but it is for dc motor current. (M113 retired dc motor pwm command)
there is also a pwm heater power setting in configuration.h of firmware of marlin, but i would advise against over powering the heater element. why is it cooling down or not maintaining temp? have you properly insulated it?
there is an extruder pwm command but it is for dc motor current. (M113 retired dc motor pwm command)
there is also a pwm heater power setting in configuration.h of firmware of marlin, but i would advise against over powering the heater element. why is it cooling down or not maintaining temp? have you properly insulated it?
|
Re: Command to increase hotend current/power? August 14, 2013 09:24PM |
Registered: 13 years ago Posts: 313 |
|
Re: Command to increase hotend current/power? August 15, 2013 11:44AM |
Registered: 15 years ago Posts: 1,797 |
|
Re: Command to increase hotend current/power? August 15, 2013 07:20PM |
Registered: 13 years ago Posts: 313 |
|
Re: Command to increase hotend current/power? August 15, 2013 08:58PM |
Registered: 15 years ago Posts: 1,797 |
|
Re: Command to increase hotend current/power? August 15, 2013 08:59PM |
Registered: 13 years ago Posts: 313 |
|
Re: Command to increase hotend current/power? August 16, 2013 08:27PM |
Registered: 15 years ago Posts: 1,797 |
[reprap.org]
go to this section a few pages down
Configuring and compilation:
if you dont want to program it, or modify firmware, then insolate the hot end really well.
go to this section a few pages down
Configuring and compilation:
if you dont want to program it, or modify firmware, then insolate the hot end really well.
Sorry, only registered users may post in this forum.